All Batteries Ireland Products

Specific vented batteries

Sun, 05 Sep 2010 15:11:10 +0100

Hawker perfect ATEX batteries are specific vented motive power batteries , using a battery container designed, patented and certified for use in Zone 1-2 (Gas) and 21-22 (Dust) areas where flammable gas or dust may occur. These batteries are designed to power electrical materials handling equipment working in potentially explosive environments.

Low maintenance batteries

Sun, 05 Sep 2010 15:11:10 +0100

The Hawker wf200 plus is a very low maintenance battery. Suitable for a wide range of applications, from light to normal duty, it allows maintenance free operation for up to 200 cycles. The Hawker wf200 plus's remarkable efficiency and economy are derived from the integration of the electrolyte circulation system, using the Airlift principle, and the unique Hawker cell design. This range complies with dimensions of standards DIN/EN 60254-2 and IEC 254-2.

Maintenance free batteries

Sun, 05 Sep 2010 15:11:10 +0100

recombination battery with gelled electrolyte, accepting up to 80% DOD C5. This range is suitable for use in forklift trucks, pallet trucks, electric vehicles and automatic transport systems. The cells have a greater capacity than most other maintenance free batteries on the market. The full benefits of Hawker evolution's high performance is optimised by using the battery in combination with our high frequency smart chargers, Lifeplus or Powertech, which allow a short charging time of only 8 hours in condition of 60% DOD or 12 hours charging time at 80% DOD C5.

Thanks to the benefits offered by the Hawker evolution technology, (no water topping up, very low gas emission, no acid leakage .), which requires a much simplified charging room, this range offers significant operational cost benefits. With minimal gas emissions it is ideal for use in sensitive environments such as the food industry. The Hawker evolution battery range is available in DIN and BS dimensions, complying with standards DIN/EN 60254-2 and IEC 254-2.

Flooded batteries

Sun, 05 Sep 2010 15:11:10 +0100

Hawker perfect plus motive power batteries provide a high level of power and reliability for all industrial truck operations, from simple applications with a low capacity loading up to heavy duty multi-shift work. Hawker perfect plus provides higher efficiency in discharge, which is achieved by the use of advanced components in the construction of the positives plates. The sizing of plates has been optimised according to volume available in the cell boxes and the process of filling the positive plates has been improved. All these technical enhancements have enabled an increase in the cell capacities while retaining the same exterior dimensions. This range is at the highest level of technology and offers very high efficiency. Available in DIN and BS series, this range complies with the dimensions of standards DIN/EN 60254 and IEC 254-2.
On request, these batteries can be supplied with Hawker aquamatic automatic single point filling system and/or with an air mixing system for reduced recharge time and increased battery availability.

TX 2000 N single-phase (Wa)

Sun, 05 Sep 2010 15:11:10 +0100

Technical features:

• Input supply 230VAC 1-phase 50/60 Hz
• BOX DIMENSIONS (mm)
• "S" 500 (L) x 400 (W) x 800 (H)
• "N" 500 (L) x 400 (W) x 1000 (H)
• "L" 600 (L) x 500 (W) x 1100 (H)
• - Standard colour : red to RAL 3000
• - Equipped with mains and battery cables

MATIC POINT Single-phase

Sun, 05 Sep 2010 15:11:10 +0100

Single-phase battery charger with Wa charging characteristic
• Digital display with readout of charging data.

Technical features:

• Single-phase input supply 230 VAC – Frequency 50/60Hz.
• Possible adjustments to 220/230/240 VAC.
• New electronic controller with AP735W card with microprocessor.
• New Software with Ah-control of the charging process.
• Polycarbonate plate with symbols easy and immediate to interpret.
• Complete switching off of charger, if it is disconnected from battery during the charging process.
• LEDs signalling the charging stages of failures, if any.
• Suitable for rated battery voltages from 12V to 96V, selectable by means of jumpers and possibility to set different values with 2V-steps.
• Trimmer for setting the threshold at 2.40V/cell.
• In the four-digit LCD with 12 multifunctional symbols, charging parameters can be recalled by means of the external ON-OFF button:
1. current delivered in real time
2. instantaneous voltage at battery terminals
3. initial battery voltage at the beginning of charging process
4. end of charge battery voltage
5. current at the beginning of the charging process
6. current at the end of charging process
7. delivered ampere-hours
8. overall charging time
• The following charging parameters can be programmed by means of DIP switches/jumpers:
1. Autostart
2. Final charge time
3. Safety timer
4. Equalizing charge
5. Proportional charge

TL EQUALIZER Single-phase

Sun, 05 Sep 2010 15:11:10 +0100

Technical features:

• Single-phase input supply 230 VAC – Frequency 50/60Hz.
• Possible adjustments to 220/230/240 VAC.
• New electronic controller with AP070 card with microprocessor. Input supply from mains: 110V/230V.
• 4 LEDs signalling the charge status or possible faults.
• Lab-tested electronic circuit conforming to Directive on Electromagnetic Compatibility and CE marking.
• Suitable for rated battery voltages from 12V to 96V, selectable by means of jumpers.
• Trimmer for setting the threshold at 2.40V/cell.
• DIP switches to select and adjust the charging parameters:
1. Autostart
2. Final charge time
3. Quick test
4. Equalizing charge
5. Proportional charge
6. Charge reset due to battery disconnection

time E/E puls / tronic E puls E-EU / digital E / multi E

Sun, 05 Sep 2010 15:11:10 +0100

Hawker provides a wide range of advanced charging systems for all traction battery applications. All chargers are equipped with microprocessors to control the charging process. Tough powder paint coatings and electrolyte resistant membrane keypads are, of course, standard, as is full CE conformity.

Hawker tronic E puls / E-EU, digital E and multi E ranges are equipped with data memory and IRcomm interface for downloading the data records on PC.

ME/TE MSE/TSE 8MSE/8TSE

Sun, 05 Sep 2010 15:11:10 +0100

systems for all traction battery applications. All chargers are equipped with microprocessors to control the charging process. Tough powder paint coatings and electrolyte resistant membrane keypads are, of course, standard, as is full CE conformity.

LED displays provide an at-a-glance view of the state of charge.

XFC blocs

Sun, 05 Sep 2010 15:11:10 +0100

These pure lead maintenance free blocs deliver superior cycling performance (up to 1,200 cycles at 60% DOD) and very rapid recharge (less than 3 hours at 60% DOD with associated HF charger).

XFC offers complete freedom of use without the need for extended recharge periods and allowing the user to 'opportunity charge' giving near continuous machine availability : recharge whenever it is possible (during breaks, at the end of the shift).
A step forward in battery technology - gives a true 'daytime cleaning' capability in floorcare and rapid cycling in all other applications.

Maintenance free batteries (powerbloc dry)

Sun, 05 Sep 2010 15:11:10 +0100

Monobloc batteries, for light-duty traction applications, are available in two technologies; Powerbloc flooded batteries and Powerbloc Dry totally maintenance free gas recombination batteries. Both ranges can be recharged with Hawker 50 Hz or Hawker HF chargers. The Powerbloc range includes TP series (positive tubular plate) and FP series (flat grid plates). The Powerbloc Dry range includes the XP and XFC series (AGM technology) and the MFP series (gel electrolyte).

Flooded batteries (powerbloc)

Sun, 05 Sep 2010 15:11:10 +0100